Informations

  

Envirnoment Audit

Environmental audit is a technique for integrating the interest for the industry and the environment, so that these could be mutually supported . This technique is basically a part of industry ' s internal procedure in meeting there responsibilities towards better environment.

This is a management tool comprising a systematic, documented, periodic, and objective evaluation of how well the management system's are performing with the aim of:

Waste prevention & reduction, Assessing compliance with regulatory requirements and Facilitating control of environmental practices by a company's management and for placing environmental information in the public domain.

In Industries like the chemical industries, the raw materials are used in excess of stoichiometric requirements because of the limitation on practically achievable operational efficiency and the raw materials purity. These excess of raw materials unless recovered, find the way to environment causing pollution. This may be in the form of gaseous, liquid, and solid phases. The waste generation may vary hourly, daily or seasonally. In this growing complexity of problems, the concept of waste prevention and reduction can be work out more effectively.

The main aim of environmental audit in an industry are :

  • To identify the areas of water uses & waste water generation / to determine the emissions, there sources, quantities / to determine the solid waste, hazardous waste generation, there sources, quantities and their characteristics.
  • To identify the possibilities of waste minimisation, recovery and recycling of waste.
  • To determine the impact on the surrounding environment i. e. ground water, stream, residential area, agricultural area, sensitive area due to the disposal of waste water, emissions and solid waste from the industry and accordingly identified suitable measures if necessary.
  • To check the effectiveness of the organisational set -up of the industry with special reference to technical viewpoint, attitudinal view point as well as environmental policy of company.

Environmental Auditing has a great benefits to the industry as well as to the Society / Nation. The main benefit of environmental audit are:-

  • The performance or the efficiency of the process systems and the pollution control systems.
  • Cost saving, which can be increased through reduction in raw material consumption by way of waste minimisation, and adoption of recycle / recovery / reduction in pollution load. Nothing is waste, the waste of one place can be useful at another place. Sometimes it helps us for maintaining the zero discharge.
  • Increase awareness of environmental requirements.
  • Helps in understanding the technical capabilities.
  • Provides the data for the requirement of plant modification.
  • Ensures independent verification, identifies matters needing attention, and provides timely warning to management on potential future problems.
  • Helps to safeguard environment.
  • To determine the mass balance of various materials used and the performance of various process equipments, so as to identify usage of materials in excess than required ; to review the conversion efficiencies of process equipment and accordingly fix up norms for equipment / operation performance and minimisation of the wastes.

The environmental audit helps in pollution control, improved production, safety and health and conservation of natural resources and hence its overall objective can be stated as achieving of sustainable developments.

However for conducting environmental audit, objectives are to be defined clearly, or else the audit procedure will be subject to varying interpretations which may yield and contribute to differences in approach thereby influencing the end results.

But generally the industries are avoiding the environmental auditing system or just taking as to fill the formality, and not getting the interest in the actual monitoring, for example flue gas coming out from the chimney is giving the performance of the boiler and the quality of the fuel. After getting the flue gas monitoring report industry can improve the boiler efficiency. In the same way industry can prepare the water balance where and how much quantity required or discharged, and where and how much quantity can be recycled. Ultimately it will save the withdrawal of ground water, resulting the cost saving i. e. reduction in the pumping cost and conservation of our natural resources also.

Some of the following suggestions may be useful to the industries :

  • An appropriate inventory of raw materials will help in the material handling losses and evaporation losses.
  • Industry can fix the norms for performance of various process operations, so that the material loses can be minimised.
  • Quantities required for each operation should be determined and water usage regulated strictly. Reduction in water usage reduces the waste water.
  • Spills of materials should be restricted to enclosures, constructed for this purpose. The floor washings should be minimised.
  • Waste water may be stored and reused. The storage costs may be lower than waste treatment and disposal costs.
  • The scrubbing of gaseous emissions with a suitable chemical can yield an useful by - product. The discharges thus can be avoided by recycling or recovery of useful by - products.
  • The treated waste water can be reused for floor wash, gardening, toilets etc.
  • The process operations where emissions arise, should be provided with control equipment. Condensers can collect certain emissions which can be entirely reused. Solvent using industry is a very good example.

Don' t think environment audit is a mandatory requirement only, but it is very helpful to access the performance of the technical capabilities. In these days, concept of clean technology has come, it can be evaluated very well with the help of environment audit.

Government Policies

POLLUTION CONTROL LEGISTATION AND RELATED REGULATIONS

  • CONVERSION OF AGRICULTURAL LAND INTO NON - AGRICULTURAL LAND ( N.A. Permission ) :-The entrepreneur or industrialist can select the site for large scale industrial project considering the requirements given in 'Environmental guidelines for siting of the industry' and then follow the procedure.It is therefore necessary to submit the application to concerned Revenue Authority for the conversion of Agriculture land into Non-agriculture land. If the plot is located in the Industrial Area developed by State Industrial Development Corporation then there is no requirement of above permission.
  • NO OBJECTION CERTIFICATE :- No Objection Certificate is basically a location clearance certificate from environmental pollution control point of view. To obtain No Objection Certificate from the Board, the applicant required to furnish all relevant details in a prescribed form. Alongwith this form, the applicant is required to submit details of effluent treatment plant, air pollution control equipment and an undertaking to provide pollution control measures before commencing production. The treatability studies and design details of pollution control measures should also be submitted alongwith NOC application.
  • ENVIRONMENTAL CLEARANCE CERTIFICATE FOR CONVERSION OF LETTER OF INTENT INTO INDUSTRIAL LICENCE :- To obtain the environmetal clearance, the entrepreneur has to submit the following details to the Board :-
    • The details of proposed project site, pollution control and abatement measures ( Details of water and air pollution control measures indicating their size, treatability studies, design details etc. ) and such other relevant information as required for review from environmental angle. The Commitment to instal the appropriate equipment and to implement the measures required for the prevention and control of pollution, before commencing the production.
    • Based on the certificate issued by the Board, the State Director of industries may confirm that the site of the project has been approved from environmental angle by the Competent State Authority.
    • For large scale projects the industry is required to obtain clearance from the Department of Environment, Forest and Wildlife ; New Delhi. For this purpose the industry is required to prepare Environmental Impact Assessment Report keeping in view the guidelines for siting of the industry. Environmental Appraisal Committee, the clearance is either granted or rejected considering the suitability of site and environmental Name of owner or occupier.
  • CONSENT UNDER THE WATER ( PREVENTION AND CONTROL OF POLLUTION ) ACT - 1974 :-As per the provision of the section 25 & 26 of the Water ( Prevention and Control of Pollution ) Act - 1974, the industry has to obtain consent of the Pollution Control Board for creating or continuing an outlet and bringing it into use for the discharge of effluent. In case the industry is existing before the commencement of this Act, Section 26 is applicable while for the proposed industry ( after Commencement of the Act ), Section 25 is applicable.

To fulfil the statutory requirement of the section 25 & 26 of the Water Act - 1974 ( to obtain consent of the Board ), the industry is required to submit application in prescribed form. Alongwith other details specified in this form, the applicant is required to furnish the following documents :-

    • Demand Draft of consent fee based on investment.
    • Analysis report of effluent duly collected and analysed by any one of the recognised laboratories of the Board.
    • Site Plan.
    • Details layout plan of factory premises, sewers for sewage, industrial effluent lines, effluent collection, treatment and disposal system and final point of disposal of effluent.
    • Details of effluent treatment units.
    • Details of manufacturing process with schematic diagram.
    • List of the name of the Director / Partners with address.

The consent application should be signed by Competent authority. Sometimes the industries provide common effluent treatment facilities and thus the outlet for the discharge of effluent becomes common. In such cases, all concerned industries are required to make common application and it should be signed by competent authority of each industrial unit.

After the grant of consent the Board starts monitoring. The industry is required to provide necessary arrangements for inspection of effluent treatment plant, effluent sample collection, flow measurement etc. The industry is also required to submit analysis reports of effluent at a frequency specified in the consent order.
As per the provision of Section 31, of the Act, the industry is required to intimate the Board, the occurance of accidental discharge or other unforseen act or event which is likely to pollute stream or well or any other receiving body. The Board may issue prohibitory order restraining or prohibiting the industry from discharging polluting matter.

  • CONSENT UNDER THE AIR ( PREVENTION AND CONTROL OF POLLUTION ) ACT - 1981 :-To obtain consent of the Board, the industry has to submit application in prescribed form and the list of specified industries is also given in this form.

Alongwith other details specified in this form, the applicant is required to furnish the following documents :-

    • Demand Draft of consent fee depending upon the investment of the industry.
    • Analysis report of gaseous emission.
    • Details of air pollution control devices installed or proposed to be installed.
    • Ambient air quality report.
    • Site Plan and topographical map.
    • Details layout plan of different process plants clearly indicating point source of emissions and positions of stacks/ chimney.
    • Process flow chart.
    • Type of fuel, its quality and consumption.
    • Details of all stacks / chimney ( height, diameter etc.).
    • The consent application should be duly signed by Competent authority. After scrutinising the application the Board grants consent specifying various conditions.

After the grant of consent the Board starts monitoring to varify the compliance of consent conditions. The industry is required to provide necessary arrangements for collection of gaseous sample ( stack monitoring arrangement ) and inspection of pollution control equipment. The industry is also required to furnish relevant details to the Board as and when asked for as per the provision of Section 25 of the Act.

The industry is required to intimate the Board, the fact of occurance or the apprehension of occurance of excessive emission of pollutants due to accident or other unforseen act or event.

  • PAYMENT OF WATER CESS UNDER THE PROVISION OF THE WATER ( PREVENTION AND CONTROL OF POLLUTION ) ACT - 1977 :-The objective of this Act is to arrange the financial resources of the Board and to incourage the industries to provide effluent treatment plant to claim the rebate. The Act provides for the levy and collection of cess on water consumption. The following procedure is required to be followed to fulfil the requirements of the provisions of this act :-
    • Every consumption ( Industry, local body ) is required to furnish on or before the 5th of the every month, to the Board a return in a prescribed form showing the quantity of water consumed in the previous month.
    • Every consumer is required to provide a separate meter for assessing the quantity of water used for different purposes.
    • Every consumer is required to pay the amount of Cess to the Board on receipt of assessment order.

The rate of Water Cess varies based on the purpose for which water is consumed. There is a provision for getting rebate of 25 % of the Cess amount assessed where a consumer instals effluent treatment plant and operate in to treat the effluent and render in to conform to the standards specified in the consent order issued under the Water Act - 1974.

  • THE ENVIRONMENT ( PROTECTION ) ACT - 1986 :-
    • The objective of this Act is the protection and improvement of environment.
    • Under the provision of Section 5 of the Act, the authority has power to issue orders for closure of the plant if the industry is found violating the standards specified for discharge of liquid effluent and gaseous emission.
    • Subject to the provision of this Act, the Central Government is having the power to take all such measures as it deems necessary or expedient for the purpose of protecting & improving the quality of the environment & preventing controlling and abating environmental pollution.
  • ENVIRONMENT STATEMENT REPORT :-Under the Rules ' The Environment ( Protection ) Act - 1986 ' & ' Amendment Rules - 1993 ', the industry has to submit Environment Statement in a prescribed form by 30th Sept. for the financial year ending the 31st March.
  • THE HAZARDOUS WASTE ( MANAGEMENT & HANDLING ) RULES - 1989 :-As per the provision of Section 6, 8 & 25 of 'Environment ( Protection ) Act - 1986 ( 29 of 1986 ) ' the Central Government enacted " The Hazardous Waste ( Management & Handling ) Rules - 1989 ". The industry has to obtain the authorisation for collection / reception / treatment / transport / storage / disposal of hazardous waste. The application should be made in the prescribed form.
  • THE NOISE POLLUTION (REGULATION & CONTROL) RULES - 2000 :- Industry should adopt Ambient Air Quality Standards in respect of Noise as 75 dB in Day time and 70 dB in night time.
  • THE PUBLIC LIABILITY INSURANCE ACT - 1991 :-The Public Liability Insurance Act - 1991 ( Central Act 6 of 1991 ) as amended in 1992 ( 11 of 1992 ) is one of the most important legislative measures enacted in India on the issues related to accidents involving hazardous substances and safeguard of interests of general public.
  • THE CHEMICAL ACCIDENTS (EMERGENCY PLANNING, PREPAREDNESS AND RESPONSE) RULES, 1996 :-It covers the accident due to the handling of any hazardous chemical. It requires the Off - Site emergency plan, On site emergency plan and emergency preparedness.
  • THE BIO-MEDICAL WASTES (MANAGEMENT AND HANDLING) RULES, 1998 :-Safe disposal of bio-medical waste. It requires the authorisation from state pollution control board.
  • THE RECYCLED PLASTIC MANUFACTURE AND USAGE RULES, 1999 :-It requires the permission from the state pollution control board under certain conditions.
  • THE MUNICIPAL SOLID WASTES ( MANAGEMENT AND HANDLING) RULES, 2000 :-Safe disposal of the domestic solid waste and every municipal authority is responsible for collection, segregation, storage, transportation, processing and disposal of municipal solid waste.
  • OZONE DEPLETING SUBSTANCES (REGULATION) RULES, 2000 :-Ozone depleting substance produced or consumed as specified by the government (MOEF) is covered under this Act.
  • THE BATTERIES (MANAGEMENT AND HANDLING ) RULES, 2001 :-The rule shall apply to every manufacturer, importer, re-conditioner, assembler, dealer, recycler, auctioneer, consumer, and bulk consumer involved in manufacture, processing, sale, purchase and use of batteries or components thereof.
  • THE MOTOR VEHICLE ACT 1989 :-All details as per the Act.
  • THE PETROLEUM ACT, (EXPLOSIVE) 1934 :-All details as per the Act.
  • THE INDIAN EXPLOSIVE ACT & RULES 1983 :-All details as per the Act.